eutectoid

eutectoid怎么读

英式音标：[ju:\'tektɔɪd]

美式音标：[ju\'tektɔɪd]

eutectoid的意思释义

n.

类低共熔体；

adj.

类低共熔体的，共析的；

eutectoid用法及例句

词组短语

eutectoid transformation共释变态；共析转变；共析蜕变

例句参考

Microstructural development of sub-eutectoid aged MgO-ZrO 2 alloys

Kinetics of austenite-pearlite transformation in eutectoid carbon steel

Evidence for cavitation in the superplastic Zn-22 Pct Al eutectoid

Creep at low stress levels in the superplastic Zn-22% Al eutectoid

Factors influencing ductility in the superplastic Zn-22 Pct Al eutectoid

Modeling of the liquid/solid and the eutectoid phase transformations in spheroidal graphite cast iron

The transformation hardening of steel surfaces by laser beams—I. Hypo-eutectoid steels

Application of the divorced eutectoid transformation to the development of fine-grained, spheroidized structures in ultrahigh carbon...

Mathematical model of heat flow and austenite-pearlite transformation in eutectoid carbon steel rods for wire

eutectoid相关例句

1. These two constituents form a eutectoid structure known as pearlite when the steel is cooled slowly enough to reach equilibrium, but by rapid cooling the steel is hardened.

当钢材冷却得足够缓慢而达到平衡状态时，这两种结构会形成一种共析结构，称为珠光体，但如果快速冷却，钢材将被硬化。

chazidian.com

2. It was found that the superplasticity was also obtained directly by superplastic treatment of the cast Zn-Al eutectoid alloy.

研究指出，直接由铸造的锌铝共析合金进行超塑性处理，也可以得到超塑性。

3. Different spheroidizing technologies were applied to the hot-rolling ultra-high carbon steel by DET(divorced eutectoid transformation).

利用离异共析原理，采用不同的热处理工艺球化热轧超高碳钢。

4. To reheat hardened steel or hardened cast iron to some temperature below the eutectoid temperature for the purpose of decreasing hardness and increasing toughness.

重新加热硬化钢或硬化铸铁至某一温度，低于共析温度下，使硬度降低，韧度增加。

5. At 727℃(1341℉), the austenite is of eutectoid composition (0.77% carbon) and further cooling transforms the remaining austenite to pearlite.

在727℃（1341℉）时，奥氏体为共析组成（含碳量0.77%），再冷却剩余的奥氏体就转化为珠光体。

7. At the last, the steps mechanism of pearlitic growing and some eutectoid structures of non Fe-C alloys are pointed out.

较后讲述了珠光体生长的台阶机制及一些非铁碳合金的共析组织。

lib.cqvip.com

8. Both steel iron and cast iron have the structures of eutectoid, hypoeutectoid and hypereutectoid.

钢和铸铁都有共析、亚共析和过共析这三种组织。

9. It is important to understand the difference of bainite transformation and eutectoid decomposition in steels.

研究贝氏体相变的特点，弄清贝氏体相变反应与共析分解的区别极为重要。

10. Above this point the hardness can be increased only slightly, because steels above the eutectoid point are made up entirely of pearlite and cementite in the annealed state.

高于此点，由于超过共析点钢完全由珠光体和退火状态的渗碳体组成，硬度增加并不多。

17. N. M. Treatment Used for Eliminating Hyper Eutectoid Carbide Defects in Surface Layer.

应用N.M。处理消除表层过共析碳化物疵病。

19. The resulting structure is a mixture of primary or pro-eutectoid ferrite (ferrite that formed above the eutectoid reaction) and regions of pearlite.

作为结果的组织结构是初步的共析铁素体（在共析反应前的铁素体）和部分珠光体的混合物。

25. The massive microstructure after annealing above the eutectoid temperature changed greatly. The microstructure became more uniform and more fine and the defects within it nearly disappeared.

块状组织在高于共析温度退火时，组织形态变化较大，组织变得细密均匀，且缺陷已趋于消失。

www.yidu.edu.cn

26. The massive microstructure after annealing above the eutectoid temperature changed greatly. The microstructure became more uniform and more fine and the defects within it nearly disappeared.

块状组织在高于共析温度退火时，组织形态变化较大，组织变得细密均匀，且缺陷已趋于消失。

www.yidu.edu.cn

27.eutectoid alloy

共析合金

28.The eutectoid reactions which can occur are extremely sluggish.

可能发生的共折反应是非常缓慢的。

30.eutectoid carbide

共析碳化物

31.eutectoid cementite

共析渗碳体

32.eutectoid compositio

共析成分

33.eutectoid decomposition

共析分解

34.eutectoid ferrite

共析铁素体

35.eutectoid graphitization

共析石墨化

36.The eutectoid compounds are very slow in forming.

共析物的形成是非常缓慢的。